working procedures of the Heat pump water heater

working medium is released into the high temperature
Stability of three parts -  storage tank (compressor), expansion valve (capillary), the dryer
Refrigeration four part - refrigeration evaporator, compressor, condenser and the throttle device.
Defrost parts - four-way valve
Heat pump water heater at work, working medium storage energy can be absorbed in the evaporator environmental media QA.
And start the system need to consume energy, namely the compressor power consumption QB.
At the same time working medium is released into the high temperature in the condenser heat medium QC : QA + QC = QB
heat pump air conditioner penetration rate is very high
air-source-009.jpg
So the heat output of energy for work QB and heat pump compressor from the environment to absorb heat QA combined. Enter a QB, get QB + QA, break through the traditional single transformation between different can not achieve 100% efficiency bottleneck. The heat pump technology can effect comparing is higher.
There are a lot of people think that using a heat can get three heat is impossible, but also for other products on the application of thermal recovery technology is the same while the heat pump air conditioner penetration rate is very high. People's understanding is limited in the air conditioner and power-hungry, but don't know the ratio of coal furnace or gas, more energy efficient. At present, because some of the larger stores haven't air source water heater sales, so consumer's perception of air to water heater is very low.
 
top
v