After stopping the heating, what problems should be paid attention to the air source heat pump and the heating end

Heating has stopped, and many families do not know. After heating is stopped, air to water heating system equipment and the end of the room need to be maintained. Here are some points to share with you in the maintenance of the heating system.

heat pump for heating.jpg

1. Air source heat pump precautions

When the heating is stopped, the air source heat pump device is powered off. It is recommended that the host, air to water heat pump, and the valve be shielded and shielded to prevent dust, dirt, and other debris from adhering to the heat pump fins and other major components. The shielding can also prevent the equipment from being exposed to wind, sun damage and weapon damage.

2. Heating pipe is best filled with water

Whether it is a steel radiator, a cast iron radiator or a copper-aluminum composite radiator, it is best to do full water maintenance. Full water maintenance can isolate oxygen, reduce oxygen content in the water, prevent oxygen corrosion, and extend the life of the radiator.

3. Check if there is a leak after stopping

It is advisable to carefully check whether there is any leakage at the interface after shutting down. If there is a leak, contact a professional for repair as soon as possible.

Whether it is a steel radiator, a cast iron radiator or a copper aluminum composite radiator, it is best to do full water maintenance.

4. Timely replacement of old radiators

For radiators that are not hot during the heating season, seepage of water in welds or joints, serious surface deformation, old style, etc., radiators that are still to be used should be found by professional radiator installers for inspection and repair, if necessary, as soon as possible Replace a new set of radiators. For overheated radiators and radiators that are not energy-efficient and environmentally friendly, it is recommended that they be replaced in a timely manner during the warm-up period. When replacing, choose a radiator with high safety, energy saving and long service life. Radiator cleaning method: After a heating season, the gaps and surfaces of radiators may become dirty or stained with oil and become unhygienic. This requires the radiators to be cleaned. When cleaning the surface of the radiator, use a soft towel or brush. Use daily detergents, weak alkaline soap water, etc. to help clean. Do not use any kind of organic solution.

5. Warming equipment should be cleaned in time

The water in the floor heating pipe is circulated for a long period of time. The water contains a large amount of microorganisms. Under certain conditions, a large amount of biological mud, bacteria, and scale will be generated on the inner wall of the pipe. In severe cases, it may also be blocked. Therefore, it is best to perform a thorough cleaning of the floor heating pipe after the heating is stopped, and to thoroughly remove the dirt, impurities, and bacteria formed in the pipe in order to prevent the pipeline embolism caused by deposits formed in the pipeline.

top
v